Desa (V)T36ENA SERIES - Manual (Page 24)

111251-01D
For more information, visit www.desatech.com For more information, visit www.desatech.com
24
FIREPLACE INSTALLATION
Wall Switch Installation
Optional Remote Control Installation (Model WRC)
WIRING DIAGRAM
FIREPLACE INSTALLATION
Continued
WALL SWITCH INSTALLATION
The installation of a wall switch allows you to activate the gas control
valve and turn the fireplace on and off. The wall switch is to be
connected to the incoming 120 volt regular household wiring that
supplies the electricity to the fireplace. Refer to wiring diagram below.
OPTIONAL REMOTE CONTROL
INSTALLATION (Model WRC)
Note: If using optional wireless hand-held remote control, the wall
switch must be in the ON position to be operational. The remote control
then becomes the switching mechanism for fireplace operation.
1.
Open lower louver panel of firebox.
2. The WRC model receiver does not require a battery. The re-
ceiver can be installed by first plugging the short extension
cord into the fireplace receptacle. Then plug the receiver unit
into the extension cord. Finally plug the ignition module plug
into the receiver unit (see Figure 46).
3. Activate the remote handset battery by removing the insulat-
ing tab on the back of the handset (see Figure 47). The battery
is included pre-installed.
4. Once the battery is activated the unit is ready to use.
5. Close lower louver panel.
Figure 46 - Installing the WRC Remote Receiver
Fireplace
Receptacle
Remote Control
Receiver
Extension Cord
Ignition
Module Plug
Figure 47 - Installing Battery into Back of Handset
Pull to Remove
Insulation Tab
Battery Cover
12 Volt Battery
Back of
Handset
STEP DOWN
TRANSFORMER
PV
GND
PV/MV
TR
MV
TH
IGN
EV2
INCOMING MAIN
GAS SUPPLY
EV1
GAS LINE TO
BURNER
24V AC
120V AC
INCOMING
120V AC
(FUSE BOX
OR BREAKER)
OFF ON
WALL SWITCH
(NOT SUPPLIED)
GREEN BLA
CK
WHITE
120v, 60Hz, 0.7A
ELECTRICAL RATING:
BLACK
WHITE
GREEN
OPTIONAL
REMOTE
CONTROL
WIRING DIAGRAM
Pilot Burner
Pilot Gas
Line