Exacq Enterprise System Manager User Manual - Manual (Page 35)

www.e x acq.com
Page 35 of 37
6/9/2015
To add a Failover Group, complete the following steps:
1. Select [add] next to Failover Groups (or click Add Failover Group from the Failover Group List).
2. Enter a name for the Failover Group.
3. Select one or more spare servers. Servers are designated as spares on the server configuration page (see
the “Add A Server” section of this document for more information). Any designated spare server that has
not been associated with another failover group can be selected.
4. Select one or more protected servers. Cameras connected to these protected servers will be
automatically recorded on a spare server if the protected server fails.
5. Select a timeout value, which is the number of seconds the protected servers must fail to record before
the automatic failover begins.
6. Click Apply to add the failover group to the Failover Group List, as shown on the previous page.
1
2
3
4
5
6