ETA Multiplo - Manual (Page 26)

26
GB
Attention: Ingredients of excessive weight must be removed from the scale to avoid
damage of the scale.
Error messages shown on display
Battery symbol – low batteries, remove batteries
EEEE – overload, the weight exceeds 3000 g
- - - – unstable zero position
VI. MAINTENANCE
Turn the appliance off and unplug the fork of the supply cord after finishing work
and before each maintenance! Do not use rough and abrasive cleaning agents (e.g.
sharp objects, scrapers, diluents or other dissolvents)! To clean the propulsion unit A
and stand B use soft damp cloth with soap. Make sure that water does not get to the inner
parts. Wash other accessory immediately after use in hot water with soap, rinse with clean
water and wipe dry (you may use the dishwasher – not for the blender G). The end with the
thread of the blender G must not be immersed during cleaning (pic. 6). Work very carefully
when cleaning the blender, the knife is very sharp! Make sure that the cutting edges of the
blender do not come in touch with hard objects that blunt them and thus decrease their
effectiveness.
Some foods may discolour the accessory. This has, however, no effect on the functions
of the appliance and is no reason to take the appliance back. This discoloration usually
disappears with time. Never dry the plastic die-cast over a heat source (e.g. stove,
cooker, radiator).
Storing the appliance and accessory
Wind the supply cord A8 over the rear part of the propulsion unit A and secure it with a
clasp after cleaning (pic. 7). Store the propulsion unit in a dry, dustless place,
out of reach of children and persons sui juris.
Store accessory E, F, G, and H in rack K (pic. 8). Secure the submersible blender G
in the rack by turning it 45 °.
VII. ENVIRONMENTAL PROTECTION
If the dimensions allow, there are labels of materials used for production of packing,
components and accessories as well as their recycling on all parts. The symbols specified
on the product or in the accompanying documentation mean that the used electrical or
electronic products must not be disposed of together with municipal waste. For proper
disposal, hand them over at the special collection places where they will be accepted free
of charge. Suitable disposal of the product can help to maintain valuable natural resources
and to prevent possible negative impacts on the environment and human health, which
could be the possible consequences of improper waste disposal. Ask for more details at
the local authority or at a collection site. Fines can be imposed for improper disposal of this
type of waste in agreement with the national regulations. If the appliance is to be put out
of operation, after disconnecting it from power supply we recommend its cutoff and in this
way it will not be possible to use the appliance again. Remove the dead batteries from the
rack (for ETA 3088) and dispose them by the means of collection networks intended for this
purpose. Never dispose of the batteries by burning!