ETA Multiplo - Manual (Page 25)

25
GB
Stand/holder (A7)
It serves to put away the mixer or to hang it when storing (when folded out) (pic. 5).
Side rack (K)
The stand serves for space-saving storing of accessory.
V. USING THE BUILT-IN SCALE – for ETA 3088
The scale is intended for weighing ingredients in the rotary bowl D. Weigh the ingredients
only when the bracket B1 is folded out.
Control panel
display – shows the weight measured, symbols of functions of the scale and error
messages
ON/OFF button – to turn the scale on/off
TARE button – to reset the scale and to set zero values
Inserting batteries
Open the battery cover on the bottom part of the stand B, insert 2 pcs of AA batteries
observing the +/- signs and replace the cover.
Weighing
1. Fold out the bracket B1 and put the rotary bowl D into the stand B.
Do not put any ingredients which you want to weigh in the bowl before turning it on!
2. Turn the scale on by pressing the ON/OFF button on the control panel B5 (display
shows all symbols for approx. 2 seconds).
3. When the display shows 0 g, the scale is ready to weigh.
4. Put the prepared ingredient in the bowl and wait till the value on the display stabilizes.
During stabilizing the left part of the display shows HOLD.
5. You can turn the scale off either by pressing the ON/OFF button or the scale will turn off
automatically after 1 minute.
TARE function
You may use this function to set zero value when weighing (adding various ingredients).
Press the TARE button to reset the display before adding each ingredient. When the
display shows 0 g, the scale is ready for next measuring.
Notes
If you remove the bowl with the weighed ingredient after resetting with the TARE button,
the display will show a negative value. If the scale turns off between individual ingredients
(due to no activity) and you wish to add/weigh other ingredients, proceed as following
before turning it on again. First lift the bowl with the ingredient from the stand and press the
ON/OFF button to turn it on. After the display shows 0 g, put the bowl back on the stand
and pressing the TARE button, reset the value on display for further weighing.
Exceeding the scale range
Maximum amount that can be weighed is 3000 g. If you weigh an item heavier than
3000 g, the display will show error EEEE. This means
that the weight of the measured item exceeds the scale‘s range.