ETA Multiplo User Manual
Page 21

21
GB
- Use the appliance in the working position only at places with no risk of turning over
and in sufficient distance from heat sources (e. g.
heater, stove, grill, etc.), and wet
surfaces (e. g.
sinks, wash basins, etc.)
- Use the appliance designed for this type only. Using another appliance can represent
a risk for the operator.
- Do not switch on the appliance without ingredients in it!
- Do not mix attachments (whisks
E and hooks F). If there are accessories in the
propulsion unit (
E or F), you can not connect blender G at the same time and vice versa.
- Do not insert the accessories in any bodily orifices.
- If the propulsion unit is operating, do not remove the accessories (e.g.
whisks, hooks,
blender), bowl, lid and do not fold out the bracket of the stand!
- Make sure the supply cord does not get between the rotating parts of the accessories.
- Working attachments can not be replaced during operation of the propulsion unit due to
safety.
- Check if the switch
A1 is in position 0 (off) before each plugging in of the appliance and
unplug the appliance after finishing work.
- Turn the device off and unplug from the power source by pulling the plug out of the
socket before replacing any attachments or accessible parts which are moving during
operation (before installing or uninstalling, before cleaning or maintenance).
- Always unplug the appliance from the power source when left unattended.
- Do not let children use the appliance without supervision!
- Do not process ingredients with temperature higher than approx.
80 °C.
- Never insert e.g.
fingers, fork, knife, spatula, spoon into rotating parts of the
appliance and the accessories.
- If the processed ingredients begin to stick on the accessories (e.g.
whisks kneading
hooks, blender knife), lid or container, turn the appliance off and clean the accessories
carefully with a spatula
L.
- Make sure the whisks do not hit the walls of the utensils during operation or do not get
stuck in the thick matter or frozen ingredients.
- Check the condition of the supply cord regularly.
- Prevent the supply cord to hang loosely over the edge of the working desk where
children could reach it.
- The power cord must not be damaged with sharp or hot objects, open fire, it must not
be sunk into water or bent over sharp edges.
- If you need to use the extension cord, it has to be uncorrupted and it has to comply with
the valid standards.
- When storing, do not place any objects on the surface of the scale, it could be
damaged.
- If you are not going to use the scale for a longer period of time, remove the batteries
from the stand.
- If the batteries are leaking, replace them immediately.
- Dispose of the old batteries appropriately (see paragraph
VII. ECOLOGY).
- Never use the appliance for any other purpose than for that described in these
instructions for use!
- The producer does not undertake any responsibility for damage caused by improper
use of the appliance and the accessories (e.g.
food deterioration, injury by knife
edge, fire, etc.) and its guarantee does not cover the appliance in the case of failure to
comply with the safety warning above.