beautypg.com

V. troubleshooting – ETA Digi Viento User Manual

Page 29

background image

Wipe the entire iron with a wet cloth in the cooled state and dry up. If brown film is created

on the ironing plate (e.g. when ironing starched laundry), you can remove the film by

a detergent containing fine sand. The iron is equipped with a permanent decalcification

system ANTI CA LC that does not require maintenance. But the system cannot fully

prevent creation of calcareous sediments.

V. TROUBLESHOOTING

Problem

Cause

Solution

Iron is not heated. Power supply not connected

Check the cord, plug and the socket

Display shows STAND BY sign

Set suitable program with control

H

AUTO STOP function activated

Move the iron for deactivation of the

safety function

Iron does not

create steam

There is no water in the container Pour water into the container
Steaming regulator is in 0 position Move the regulator into the steaming

position

Low temperature is set for

activating the DRIP-STOP

function

Set a program by the control

H, during

which you can use steaming and wait

till the iron is heated for using it

Iron does not

create steam

shock

Low temperature is set for

activating DRIP-STOP function

Set a program by the control

H, during

which you can use steaming and wait

till the iron is heated for using it

The function of steam shock was

used too often during a short

period of time

Let the iron heat and wait for a while

before using the electric shock func-

tion again

Sprinkling

equipment

(additional spray)

does not sprinkle

water

There is no water in the container Pour water into the container
The water system is aerated

Tighten finger on the additional spray

jet hole and at the same time press the

sprinkling device button several times

Water is dripping

from the ironing

plate

The lid of the pouring hole of the

container is not closed properly.

Close the pouring hole lid

Low temperature is set

Set a program by the control

H, during

which you can use steaming and wait

till the iron is heated for using it

The steam shock function was

used when temperature below

ooo was set

Set the program COTTON, JEANS or

LINEN by the control

The SELF CLEAN button was

pressed during ironing

Do not use the SELF CLEAN function

After finishing ironing, the iron

was put into the horizontal positi-

on and the steaming regulator is

not in

0 position

Move the steaming regulator to

0

position, empty the container and put

the iron into the rest position

29

GB

/ 74