ETA Digi Viento - Manual (Page 26)

– Make sure that the ironed fabric is tensed up properly so that steam does not leak to the sides.
– For the ironing plate A to remain smooth, protect it from direct contact with sharp metal
objects (e.g. zip fasteners, buttons, snap buttons, decorative objects).
Control
– Plug the power cord M to a socket. You will see the ETA VIENTO sign on the display, thenthe
iron is switched automatically to the stand-by regime and the STAND-BY sign is shown on
the display.
– Set the selected H program (i.e. the fabric material) using the control. By turning the
knob repeatedly to the right (i.e. in the clockwise direction), you set the programmes from
SYNTHETIC to LINEN, which means you are increasing the temperature. By turning the
knob repeatedly to the left (i.e. anti-clockwise), you set the programmes from LINEN to
SYNTHETIC, which means you the are reducing temperature.
– The respective information is shown gradually on the display using signs and symbols (fig. 9)
STAND-BY SYNTHETIC AKRYLATE sIlk WOOL CoTTN JeANs
lINeN.
– Increasing ( ) or reducing ( ) the temperature is signaled by a flashing symbol.
– Reaching the proper temperature is signaled by the TEMP.OK sign and a sound signal.
Sound signaling
– Every pushing of the control H in requirement for setting the fabric material = “1 very short beep”.
– Every pushing of the control (i.e. change of the program) = “1 short beep”.
– Reaching the temperature of the set program = “1 long beep”.
– Activation of the safety function AUTO-STOP = “permanent beeping”.
Note: when setting the STAND-BY program, every other pushing of the - control is without any
effect.
Language setting
The iron can be set to show the text on the display in Czech or English, Slovak, English,
Russian, German, Hungarian and Polish (factory setting is in Czech). If you wish to change the
language, select the LEN program using the H control, then press and hold the + control for
ca. 3 seconds. Display G will show the ĽAN sign (the display will now show fabric materials in
Slovak). Same way to set up additional languages . To change the language back, proceed the
other way.
Ironing without steaming
Put the iron to the rest position (fig. 7). Turn the steaming regulator D (fig. 5) to the 0 position,
steaming off or pour out water from the container I. Plug the power cord M to a socket. Set
the program on the display using control H according to the selected fabric material (Fig. 2).
Reaching the required temperature is shown on the display and announced by sound signaling.
WARNING
– Display G shows international symbols, that recommend the optimum ironing
temperature and they are the same as marking on some types of laundry and textiles
(Fig. 3).
– When the temperature is increased from the cold state or if the temperature is set from
higher to lower, we recommend waiting for a while (see the information on the display
and listen for sound signalling) due to stabilization of the ironing plate A temperature.
– To set the programmes, you just need to turn the knob slightly (to the right / left)
within the given range. Forcible rotation could lead to damaging the knob
!
26
GB
/ 74