beautypg.com

Iv. maintenance – ETA Digi Viento User Manual

Page 28

background image

VERTICAL SYSTEM

It is intensive vertical steaming for steaming of freely hanging textiles (such as hanging

clothes, draperies, hangings). Using control H set one of the programs for steamig. As soon

as the indication lamp

G turns OFF, stretch the fabric slightly with one hand and move the iron

vertically bottom-up (Fig. 6B

). Press the intensive steaming button

F so that you reach

vertical steam hammer. Do not hold the intensive steaming button pressed continuously and

do not use it more than 10 times consecutively.

WARNING

– Use the VERTICAL function only if the programs COTTON, JEANS or LINEN are set.

– Prevent burning of sensitive fabrics, do not close them to the iron to distance of 10 to

20 cm.

!

DRIP STOP

The appliance prevents leaking water from the ironing plate when its temperature is

insufficient.

Self-cleaning system (SELF CLEAN)

Hold the iron disconnected from power supply in your hand, turn steaming regulator

D to 0

position (Fig. 5) and lift off cover

C to open the filling container lid. Pour water into container

I using the enclosed cup

O to fill half of it and close the filling hole lid (Fig. 4) by snapping it.

Keep the position of the iron for pouring water in it. Put the iron to the rest position

(Fig. 7) and set the regulation wheel

H to the program LINEN. Plug power cord M into

a socket. When the control light

G switch off, disconnect the iron from the electric power. Hold

the iron in the horizontal position over a sink. Press the

SELF CLEAN button repeatedly (two

to three times), each time for about 5 seconds. Then wait till water stops going out from the

ironing plate. If the iron still contains a lot of impurities, repeat the procedure while pushing

the intensive steaming button between individual pushing of the

SELF-CLEAN button. After

completing the cleaning, plug the iron into the electric power, set the selected program and

then iron a clean piece of cotton cloth so that the ironing plate is cleaned.

Clean the ironing

plate using the SELF CLEAN function continuously.

Safety electronics (AUTO STOP)

The safety electronics ensures switching OFF the iron plate heating within 30 seconds, when

the iron is left without any movement in horizontal position or when it is tilted over to one

side, or within 10 minutes, when it is left in vertical position. Function of safety electronics is

signalled by flashing of indicator lamp

G and by acoustic signal (beep). The iron is restarted

automatically, when the ironing is resumed.

Storage

After finishing ironing, pour out the unused water from the container (be careful, it can be hot),

or let the rest of the water evaporate and let the iron cool down. Then turn regulator

D to 0

position (steam switched off). Wind power cord

M over the back side of cover L and put the

iron to the rest position (Fig. 8) out of reach of children and incapacitated persons.

IV. MAINTENANCE

Before every maintenance, unplug the iron from power supply by taking the fork of the

power cord out of the socket! Do not use rough and aggressive detergents (e.g. sharp

objects, peelers, pot scourers, caustic agents for cleaning or other solvents).

28

GB

/ 74