ESI Waveterminal 192L - Manual (Page 29)

ESI Waveterminal 192
30
1. Pull Down Menu
The Waveterminal 192X
control panel includes a pull down menu bar that contains the
configuration menus for the Control Panel.
1. File - Exit
File – Exit will close the Waveterminal 192X
Control Panel window but it will not shut
down the Control Panel. You can always launch the Control Panel by clicking icon
on the system tray.
2. Config – Mouse Wheel
Mouse Wheel will control the mouse wheel adjustment. When you use the mouse wheel
to adjust the volume level, the adjustment step is set to
±1.5dB as default. You can
configure the adjustment steps to your preference.
- Step 1: When you move the mouse wheel one step, the fader will move by
±1.5dB.
- Step 2: When you move the mouse wheel one step, the fader will move by ±3.0dB.
- Step 4: When you move the mouse wheel one step, the fader will move by ±6.0dB.
- Step 8: When you move the mouse wheel one step, the fader will move by ±12.0dB.
3. Config – Latency
This will decide the latency of the Waveterminal 192X. You have to set proper latency
depends on your situation. Generally, higher latency is fit for Multi-track recording
software using multiple tracks. Process time maybe longer, but it’s stable. Lower latency
is fit for software synthesizer, mastering software or Multi-track software using only
few tracks.
4. Config – Factory Default
This returns all the Waveterminal 192X configurations to factory default setting.
5. Config - Always On Top
This will set the Waveterminal 192X control panel to always over other Windows. If
this is not selected, the active windows will be set over the Waveterminal 192X Control
Panel.
6. Config - Card
In the case of using two or more Waveterminal 192X in one computer system, this