ESI Waveterminal 192L - Manual (Page 19)

ESI Waveterminal 192
20
1. LINE IN L – Analog Input 1 (Left channel, Mono)
This is Left analog Line input. It is mono and +4dBu balanced connection.
Two analog input of Waveterminal 192X are balanced mono channels.
You can use Balanced or unbalanced cable for this port.
2. LINE IN R-Analog Input 2 (Right channel, Mono)
This is Right analog Line input. It is mono and +4dBu balanced connection.
3. 4. Analog 1,2/3,4 Output (stereo)
These are stereo Analog Outputs. Analog 1,2 send out the signal indicated as ‘1-
waveterminal 192 2ch’ on application’s device set up. Analog 3,4 send out the signal
indicated as ‘2-waveterminal 192 2ch’ on application’s device set up.
5. Analog 5,6 Output/Headphone Out(stereo)
This is stereo analog output. Same as Analog 1 2 / 3 4, this output use stereo TRS phone
plug. Analog 5,6 send out the signal indicated as ‘3-waveterminal 192 2ch’ on
application’s device set up. This output port is also used as headphone connector.
Waveterminal 192X provides high quality headphone amp.