Entone Hydra HD A-Series - Manual (Page 34)

Hydra HD – A Series User’s Guide
Copyright     2008 Entone, Inc. All rights reserved . 32
ATTACH THE RF REMOTE CONTROL ANTENNA
You need to attach the RF Remote Control Antenna to the Hydra HD’s rear panel “REMOTE ANTENNA”
input in order to use the radio control remotes.
Figure 10-3 Attaching Remote Control Antenna
NOTE: Be sure to set the antenna straight up so that you can use the remote control from as far away as
possible. Don’t let the antenna touch anything.
ATTENTION: If your remote control isn’t working very well from far away, you may be experiencing
interference from objects near your receiver. To improve your remote control’s range, try any or all of the
followings:
1. Place the receiver higher than all of the other equipment in your entertainment center.
2. Provide room above the receiver so that the antenna can be installed straight up. If this is not possible,
tilt the RF Antenna at about a 30° angle.
3. Place the RF antenna outside the entertainment center by using a coaxial cable to connect the antenna
to the Hydra HD.
4. Try moving the Hydra HD to other locations.