Entone Hydra HD A-Series User Manual
Page 23
Copyright
2007 Entone, Inc. All rights reserved
21
Chapter
5
5.1 Connecting TV(s) In Other Rooms
This section describes how to connect the Hydra HD to the cable-ready remote TV(s) located in another
room(s) away from the Hydra HD. This installation uses your in-home TV cabling system. If your house
does not have built-in TV cabling, it will be necessary to run cables from the Hydra HD to each remote TV.
Due to the difficulty of this installation, you should consider having this professionally installed.
NOTE: When connecting to the in-home cabling system, you must meet the FCC requirements. To meet
these requirements, an in-line coaxial attenuator may need to be installed using the following guidance:
If connecting to your in-home cabling system to distribute the signal to TV(s) in other rooms, in most
cases you will not have to install the attenuator on the “MATV OUT” port for typical in-home cabling
systems.
If connecting directly to a TV tuner port, you must install the attenuator in the cable between the
“MATV OUT” port and the TV tuner.
Figure 5-1 Connecting Attenuator