Eizo DuraVision FDU2101 / FDU2101T 取扱説明書 - Manual (Page 19)

7
English
●
How to connect
1.
Connect the signal cables to the input signal connectors and PC.
Check the shape of the connectors, and connect the cables.
After connecting the signal cable, tighten the screws of the connectors to secure the coupling.
Analog connection
(D-Sub)
Digital connection
(DVI)
or
MD-C87
FD-C39 (option)
2.
Plug the power cord into a power outlet and the power connector on the
monitor.
1. Lift the power plug fall prevention bracket and connect the power cord to the power connector. After the
connection, turn down the bracket and then fix the power plug.
2. Connect the power cord to the power outlet.
Fall
prevention
bracket
To power outlet
Clamper
Cable holder
After connecting the power cord, pass the clamper through the cable holder and secure the cord with the
clamper.
Displaying the Screen
1.
Press to turn on the monitor.
The monitor’s power indicator lights up green.
2.
Turn on the PC.
The screen image appears.
If an image does not appear, refer to “No picture” (page 9) for additional advice.
If using the FDU2101T proceed with installation and calibration of the touch panel driver.
Attention
• Turn off the monitor and PC after using them.