DR Power Powerwolf Power Wagon - Manual (Page 14)

8 DR

Powerwolf

Safety & Operating Instructions
Unpacking the DR Powerwolf
The DR Powerwolf is shipped fully assembled, fixed to a pallet.
Tools & Supplies Needed:
§ Screwdriver
§ Hammer
§ Knife
§ Gloves
§ Eye protection
§ Metal shears
WARNING! Always wear eye protection when cutting the banding that
secures the DR Powerwolf to the pallet. The banding may have a lot of tension
on it and may snap, striking you when cut. Always stand to one side when
cutting the band.
1. Carefully remove the wrapping from the machine.
2. Stand to one side and cut the banding.
3. Remove the wheel blocks.
4. Cut any ties holding the machine to the pallet.
5. Put the machine in free wheel mode (see page 16), release the parking brake, and
roll the DR Powerwolf off the pallet. Do not discard pallet and packaging material
until you are fully satisfied with your machine.
WARNING! Be sure to fill your engine with oil and gas before use in
accordance with the Safety & Operating Instructions.
Check the Tire Pressure
The recommended tire pressures are listed below.
§ Front tires: 12 PSI (14 PSI Max.)
§ Rear tires: 20 PSI (22 PSI Max.)
Note: The heavier the load, the higher the tire pressure should be. Do not go above the
maximum recommended load or pressure.