DR Power 8.25 Pro Power Wagon (February 2007 - February 2009) - Manual (Page 37)

CALL TOLL-FREE 1-800-DR-OWNER 33
THE CINDER BLOCKS MUST BE REPLACED AND SECURED WITH THE STRAP FOR STABILITY WHEN
DUMPING AND FOR TRACTION ON SLOPES WITH LIGHT LOADS.
Front & Rear Nuts to Loosen
Removing and Replacing the Cinder Blocks
WHEN PERFORMING ANY MAINTENANCE, YOU MUST FIRST SHUT OFF THE ENGINE, SET THE
PARKING BRAKE, WAIT FIVE (5) MINUTES TO ALLOW PARTS TO COOL AND DISCONNECT THE SPARK
PLUG WIRE, KEEPING IT AWAY FROM THE SPARK PLUG.
Tool Needed:
•
7/16" Wrench
1. Position the machine on a level surface and set the Parking Brake.
2. Tip the Bed forward.
3. Loosen the Bolts and Lock Nuts with a 7/16" Wrench on the Front and the Rear of the Weight Rack
Block Strap (Figure 30).
4. Pull the Strap up and off, and then store the Strap in a safe place.
5. Remove the three (3) Cinder Blocks.
Dump Activator Maintenance
For the Electric Dump System, the dump activator is a sealed unit that does not need servicing under
normal use.
DO NOT USE A POWER WASH SPRAY UNIT TO CLEAN THE ACTIVATOR. SERIOUS DAMAGE TO THE
SEALS MAY RESULT.
Weight Rack Block Strap
Figure 30