DR Power Power Wagon 4 x 2 8hp B&S (April 2002 - March 2004) User Manual
Page 9
Page 9
Transporting the DR® POWERWAGON™ 4 x 2
• The DR® Powerwagon™ 4 x 2 can be transported in the bed of a full size pick up truck
or vehicle that can accommodate a pallet 45 x 108 inches, weighing 750 lbs.
• You will need:
• The DR® Powerwagon™ 4 x 2 is shipped fully assembled, fixed to a pallet. The pallet
can only be loaded on your vehicle one way at the trucking depot. The front of the DR®
Powerwagon™ 4 x 2 will be towards the front of the truck.
• Secure the DR® Powerwagon™ 4 x 2 to your vehicle.
• Upon arrival at home, carefully remove the wrapping from the machine, cut the banding
and remove the wheel chocks.
• Place the ramps from the back of the pallet to the ground. Make sure that the ramps are
lined up with the wheels.
• DO NOT ATTEMPT TO DRIVE THE VEHICLE DOWN THE RAMPS WITH THE
ENGINE RUNNING. DO NOT STAND BEHIND THE VEHICLE WHEN
OFFLOADING.
• You should become familiar with the controls prior to unloading. Please be sure to know
the location of the hand and foot brake as well as the gearshift.
• Be sure to read the Safety and Operating Instructions provided with your machine before
attempting to operate the DR® Powerwagon™ 4 x 2.
• 2 Ramps ( 2 x 10 x 7 ft. long)
• Wire cutters
• Knife
• Hammer
• Screwdriver
• Two helpers