DR Power Mini Tiller Roto-Hog (January 2015 - Present) User Manual

Page 17

Figure 15

27759 Border-Edger Kit Installation (Optional Accessory)

The Border-Edger Kit is a useful tool for making clean cuts in the
lawn along the borders of gardens, flower beds, walkways, and
driveways for a well manicured look. To install the Border-Edger
Kit, do the following:

INSTALLATION

1. Make sure the Tiller is not running by flipping the ON/ OFF

switch to the OFF position.

2. Remove the hairpins from both sides of the tine shaft

(

Figure

)

3. Remove the cultivating tines from the shaft, remembering

which direction they are facing.

4. Put the tines in a safe place and save the two hairpins, they will

be used on the Border-Edger Kit.

5. Slide the border-edger tine onto either side of the tine shaft.

Make sure that the hub collar of the border-edger tine faces
outward, away from the transmission of the Tiller.

6. Take the two hairpins saved in

Step 4

and insert them through

the inner and outer holes in the tine shaft on each side of the
border-edger tine to secure the tine blade in place on the shaft.

7. Slide the border-edger wheel onto the opposite side of the tine

shaft as far as it will go.

8. Insert the one remaining hairpin, that came with the kit,

through the inner hole next to the wheel in the middle of the
tine shaft.

9. Before using the Border-Edger Kit, remove the drag stake from

the unit.

10. Set the Tiller wheels to the HIGHEST (top) position.

PARTS BREAKDOWN

Key #

Part #

Description

Qty.

1 36015

Border-Edger

Tine

2 36016 Border-Edger

3 36017 Hairpin 1

Figure 16

Be aware that the Tiller could unexpectedly bounce upward, or jump forward if the tines strike concrete, pavement, or
other hard surfaces or hard obstacles buried under ground.