DR Power Premier Tow-Behind Power Tiller Roto-Hog (Dec. 2012 - Present) User Manual

Page 9

1. Using Pliers, carefully untwist the Wire Banding at the one corner where they

are twisted together (Figure 2). Be careful of the Wire Ends; they may be
sharp. Open the untwisted corner out like a door so the bottom of that Panel
is clear of the overhanging boards on the Pallet (Figure 2).

2. Remove the Lag Screw that holds the SMOOTH-TRAK™ Hitch to the Packing

Skid.

3. Lift the open end of the Crate up and towards the other side to remove the

crate from the Pallet.

4. Cut the Zip-Ties from around

the Axle at the rear of the Carton.

Remove and save the two (2) Flat Washers and Cotter Pins from the rear Axle.
Reuse them when attaching Gage Wheels.

6. Remove the Hardware Bag from on top of the Gas Tank of the machine.

Assemble the Gauge Wheels onto the Rear Axle with the extended end of the
Hub facing inward. Secure with the Flat Washers and Cotter Pins that were
removed from the Axle during the unpacking (Figure 3).

8. Attach the SMOOTH-TRAK™ Hitch to your Tow Vehicle Draw Bar. See page

11.

9. Remove the pre-assembled 3/8" x 2" Hex Bolt and 3/8" Lock Nut from the left

hand Tine Assembly (Figure 4).

10. Slide the Tine Assembly onto the Transmission Axle on the left side of the

Tiller and secure with the Hex Bolt and Lock Nut (Figure 4). Repeat for the

other side.

11. Do not discard your packaging material until you are fully satisfied with

your new DR ROTO-HOG Premier Power Tiller.

Figure 2

UNTWIST
WIRES

Figure 3

Figure 4