DR Power Premier Tow-Behind Power Tiller Roto-Hog (Dec. 2012 - Present) - Manual (Page 18)

18 DR ® ROTO-HOG™ Premier Power Tiller
Do not move or remove the Belt Guide (Figure 10). If you accidentally alter the position of the Belt Guide, return it to the correct
setting of 6-1/2" above the Tine Shield Support Plate (Figure 10).
Transmission Lubrication
Check the Transmission Oil Level after the first 5 hours of operation. Remove the Oil Fill Plug (Figure 9 on page 17). The Oil level
must be even with the Plug Hole (with the Tiller level). Add Oil if necessary. Use SAE 30 non-detergent motor Oil. Replace Oil Fill
Plug.
NOTE: It is not necessary to change the Oil in the Tiller Transmission. If for any reason it must be changed, Oil capacity is 22 oz.
Removing and Replacing the V-Belt
Replace the Tine Drive V-Belt if damaged from slipping under heavy loads or if it shows cracks or frayed edges.
Tools and Supplies Needed:
• Screwdriver
•
7/16" Socket
1. Remove the Screw from the top of the Belt Guard (Figure 11).
2. Remove the Hex Nut from the rear of the Belt Guard using a 7/16" Socket and
remove the Belt Guard.
3. Disengage the Tine Clutch Lever and remove the worn Belt.
4. Reverse this procedure to install a new Belt.
When performing any maintenance, you must first shut off the Engine; wait five (5) minutes to allow parts to cool and disconnect
the Spark Plug Wire, keeping it away from the Spark Plug.
Figure 10
Figure 11