DR Power 13 HP Towable - Manual (Page 23)

CALL TOLL FREE 1-800-DR-OWNER 19
•
THE DESIGN OF THIS CHIPPER IS FOR CHIPPING LIMBS OR BRANCHES. NEVER USE THIS
MACHINE FOR ANY OTHER PURPOSE AS IT COULD CAUSE SERIOUS INJURY.
•
CONTACT WITH INTERNAL ROTATING PARTS WILL CAUSE SERIOUS PERSONAL INJURY. NEVER
PUT HANDS, FACE, FEET OR CLOTHING INTO CHIPPER HOPPER OR DISCHARGE OPENING OR
NEAR THE DISCHARGE AREA AT ANY TIME.
•
BEFORE PERFORMING ANY MAINTENANCE PROCEDURE OR INSPECTION, STOP THE ENGINE,
WAIT FIVE (5) MINUTES TO ALLOW ALL MOVING PARTS TO COME TO A COMPLETE STOP AND
COOL. DISCONNECT THE SPARK PLUG WIRE, KEEPING IT AWAY FROM THE SPARK PLUG. USE
ONLY A WOODEN STICK TO CLEAR JAMMED MATERIAL AFTER ALL MOVING PARTS HAVE
STOPPED COMPLETELY.
CHAPTER 4
OPERATING YOUR DR 13 HP CHIPPER
This chapter covers the procedures for starting and stopping your new DR 13 HP CHIPPER and discusses
basic operation features.
Before Starting the Engine
1. Check the oil level every time you use the DR 13 HP CHIPPER.
2. Check the gas level.
3. Turn the Gas Shut-Off valve to the OPEN (vertical) position (Figure 5).
4. Remove any debris buildup from the machine.
Figure 5
Throttle
Gas Shut-Off
(shown in Off
position)
Choke
Recoil Starter Handle
Air Filter
Electric Start Model
Manual Start-
ON-OFF Switch:
-UP is ON
-DOWN is OFF
Gas Fill