Daily checklist for the 8-ton dr wood splitter – DR Power Hydraulic 8-Ton User Manual

Page 36

DR POWER EQUIPMENT

M E I G S R O A D , P . O . B O X 2 5 , V E R G E N N E S , V E R M O N T 0 5 4 9 1

1-800-DR-OWNER (376-9637) • www.DRpower.com

Daily Checklist for the 8-TON DR WOOD SPLITTER

To help maintain your 8-TON DR WOOD SPLITTER for optimum performance, we recommend you
follow this checklist each time you use your machine.

[ ] OIL: With the machine on a level surface, check the engine oil level with the dipstick and add more if

necessary (only add oil to the level indicated on the dipstick - DO NOT OVERFILL). Use SAE 10W
30 high detergent motor oil.

[ ] GAS: Fill the gas tank with clean, fresh, unleaded gasoline.

[ ] HYDRAULIC FLUID: Check hydraulic fluid level and fill as needed.

[ ] HYDRAULIC HOSES: Check hydraulic hoses for cracks or wear.

[ ] ENGINE AIR COOLING SYSTEM: It is very important to keep the engine clean of debris. Remove wood

chips and other built-up materials from the air intake screen before, during and after you run the
Splitter. Regularly remove debris from the cooling fins. A dirty engine retains heat and can cause
damage to the internal engine parts.

[ ] WEDGE: Check the wedge for tightness, nicks and wear.

[ ] GENERAL CONDITION: Check the general condition of the machine ( e.g.; nuts, bolts, welds etc.).

[ ] SLIDE RAIL: Apply a rust preventative (Fluid Film or equivalent) to any bare metal areas on the top of the

rail. This will assure the longest possible service life of the wear pads.