Attaching the valve control handle to the valve – DR Power Hydraulic 8-Ton User Manual

Page 13

Attaching the Valve Control Handle to the Valve

1. Install the Clevis Pin and Hairpin Clip through the

bottom hole on the Valve (Figure 8).

2. Insert the forked end of the Valve Control Handle over

the Clevis Pin.

3. Align the hole in the Handle with the top hole in the

Valve and insert the top Clevis Pin and Hairpin Clip.

4. Remove the Bolt and Locknut that is securing the

wedge end of the Splitter to the shipping Bracket
(1/2" wrenches) (Figure 9).

NOTE: Set the Bolt and Locknut that was removed in the last

step aside to be used when you install the Front Leg.

Remove the Two Carriage Bolts and Locknuts that secure

the Shipping Bracket to the Plywood Base (1/2" wrenches)
and remove the Shipping Bracket (Figure 10).

Slide the Splitter out of the Shipping Bracket that is on the

opposite side and set the Splitter on a flat, clean surface.

Shipping
Bracket

Figure 9

Bolt and
Locknut

Figure 8

Valve
Control
Handle

Clevis
Pin

Hairpin
Clip

Valve

Hairpin
Clip

Figure 10

Carriage
Bolts and
Locknuts

Shipping
Bracket