Removing and replacing the engine oil – DR Power Hydraulic 20-Ton User Manual
Page 29
DR
20-Ton WOOD SPLITTER Safety & Operating Instructions
25
Removing and Replacing the Engine Oil
Tools & Supplies Recommended:
1/2" wrench
SAE 10W-30W HD,
.61 US qt. (0.58 L)
CHP Liquid Vac Oil Drainer, item # 16145 (Optional)
Note: Drain the oil when the engine is warm. Warm oil drains quickly and completely.
1. Position a suitable oil receptacle under the engine oil drain and remove the engine oil
filler cap (Figure 22).
2. Remove the engine oil drain plug using the 1/2" wrench (Figure 22).
3. Allow the used oil to drain completely, then reinstall the drain plug with washer and
tighten securely.
4. Replace the engine oil using SAE 10W-30W HD oil. See page 17.
Optional Method
1. Remove the engine oil Fill Cap and vacuum the oil from the engine through the oil fill
tube using the recommended CHP oil drainer.
2. Replace the engine oil using SAE 10W-30W HD oil. See page 17.
Note: If the oil is not to be reused, be sure to use environmentally safe disposal
procedures in the disposing of the used oil.
WARNING! Before performing any maintenance procedure, stop the
engine and disconnect the spark plug wire.
Figure 22
Important! Be certain to fill with oil before starting the engine. See Page 17.
Oil Filler
Cap/Dipstick
Washer
Drain Plug