DR Power Hydraulic 20-Ton - Manual (Page 16)

12 DR  20-Ton WOOD SPLITTER Safety & Operating Instructions
Figure 5
Log Cradle Installation (Optional)
The following procedure includes all of the steps necessary for the installation of the
optional Log Cradle on the DR 20-Ton WOOD SPLITTER.
Tool Needed:
9/16" wrench or socket
1. Mount the Log Cradle on the
operators side of the wood
splitter (Figure 5) and the Log
Cradle retaining panel on the
opposite side of the H-beam
using the three 3/8" bolts and
nuts. Tighten the bolts using the
9/16" socket.
Manual Log Lift Installation (Optional)
The following procedure includes all of the steps necessary for the installation of the
optional lever-action Manual Log Lift (Figure 6) on the DR 20-Ton WOOD SPLITTER.
Tools Needed:
1/2" wrench or
socket
9/16" wrench or
socket
1. If the optional Log
Cradle is employed,
remove the three
bolts that hold it on
(Figure 5).
2. Replace the Log
Cradle retaining
panel with the Log
Lift mounting plate,
then re-insert and
tighten the three
bolts and nuts. See
Figure 7 on page 13.
WARNING! Before performing any maintenance procedure, stop the
engine and disconnect the spark plug wire.
Log Cradle (2 shown)
3 Bolts
Figure 6