DR Power Dual Action 3 pt. Hitch Model (Aug 2011 - Present) - Manual (Page 14)

14 DR ® DUAL-ACTION 3 PT HITCH LOG SPLITTER
Chapter 5: Troubleshooting
Most problems are easy to fix. Consult the Troubleshooting Table below for common problems and their solutions. If you
continue to experience problems, contact us at www.DRpower.com or call toll-free 1-800-DR-OWNER (376-9637) for support.
Troubleshooting Table
S YMPTOM P OSSIBLE C AUSE
When the Valve Control
Handle is pushed, the
Wedge does not move.  Check the Tractor to make sure the hydraulic fluid level is correct. If the fluid is level is not
correct, fill with hydraulic fluid as described in your Tractor manual.
 Check the Tractor Hoses to make sure the hydraulic fluid is flowing. Hoses should be
vibrating when fluid is flowing.
 If the fluid level is OK then contact us at www.DRpower.com for assistance.
The Splitter lacks power  Tractor throttle is set too low; Adjust Tractor throttle.
 Tractor pressure low; Check the pressure output of the Tractor.
 If your Splitter still lacks power, contact us at www.DRpower.com for assistance.
The splitting Wedge
moves slowly, but will
split wood.  Check the hydraulic fluid level in the Tractors Hydraulic Tank and fill as necessary.
 Check the high-pressure hose, fittings, and valve openings for dirt and debris that may have
obstructed the openings.
The splitting Wedge
moves in the opposite
direction than Operator
Lever is pushed.  Hoses from Splitter to Tractor are connected to the wrong ports; Swap Hose connections.
Before performing any maintenance procedure or inspection, stop the Tractor, set the Brake and remove the Key, wait five (5)
minutes to allow all parts to cool.