DR Power Walk-Behind Pro (1985 - 2000) - Manual (Page 29)

DR
®
TRIMMER/MOWER
™
Assembly & Operating Instructions 27
· The wiring harness consists of a set of wires that lead from the ignition switch to the battery.
Disconnect and reconnect the battery wires (black to black and red to red) and check the wire
connections at the key switch.
· Call one of our Customer Service Representatives TOLL-FREE 1(800)DR-OWNER(376-9637)
for assistance.
To Remove the Mow-Ball
™
Support Assembly
WARNING: Before performing any maintenance procedures, the engine should be stopped
and the spark plug wire disconnected.
Tool Needed:
• Phillips head screwdriver
Set the machine on a bench if possible. Do not tip the machine all the way back on its handlebar
unless you have drained the gas and oil.
1. Remove the orange vinyl plug from the bearing housing outer shaft (Figure 33).
2. Insert the screwdriver into the hole (Figure 33), and rotate the Mow-Ball
™
Support until the
screwdriver fits in a second hole in the inner shaft, locking it into place.
3. Turn the Mow-Ball
™
Support assembly with your hands until it unscrews completely from the
bearing housing (Figure 34).
Figure 33 Figure 34