DR Power Walk-Behind Pro (1985 - 2000) - Manual (Page 12)

10 DR
®
TRIMMER/MOWER
™
Assembly & Operating Instructions
Step 2: Attach the Rubber Stone Guard
1. Take one of the two stone guard clamps and spread it open. Position it around the axle (Figure
5) and squeeze the ends together. Install the second clamp midway along the opposite side of the
axle in the same way. Turn the open ends of the clamps upward.
2. Holding the rubber stone guard vertically over the axle, slip one side of the stone guard in
between the clamp end so that the hole in the guard is aligned with the holes in the clamp. Insert
a 5/8" long bolt and attach a lock nut (Figure 6). Tighten with a 3/8" wrench or socket and
screw driver until the threads show. Don't over tighten. Repeat on the other side. The stone
guard should swing freely from the axle.
Step 3: Install the Wheels
1. Mount each wheel on the axle and push it
firmly against the axle stop (Figure 7).
2. Place the retaining ring on the axle, against
the wheel, and tighten the set screw with a
wrench or pliers (Figure 7).
Step 4: Set the Machine Upright
Note: Be careful not to kink, twist or stretch the
control cables.
1. Remove the front end of the Styrofoam
packing.
2. Stand at one side of the machine, hold on to
one wheel with one hand, and the nose of the machine with the other. Lift the front-end of the
machine up and over until the Mow-Ball
™
Support is resting on the ground and the machine is
upright (most of the weight is on the wheels during this maneuver).
Figure 5 Figure 6
Figure 7