DR Power 6000-Watt Generator - Manual (Page 16)

12 DR
®
GENERATOR ATTACHMENT
Installing the DR GENERATOR ATTACHMENT
1. With the help of another person to steady the
ATM power unit; line up the GENERATOR
ATTACHMENT with the ATM Attachment Pin
and slide the Generator onto the Pin (Figure 8).
2. Reattach the Collar and Retaining Pin to secure
the Generator (Figure 9).
3. Pull and release the Belt Tension Lever from the
Stow Clip beneath the Generator (Figure 10).
4. Install the supplied Drive Belt on the Engine
Pulley below the ATM (Figure 10).
5. Route the Drive Belt around the Generator Belt
Tension Pulley and the Generator Drive Pulley
(Figure 9).
6. Push the Belt Tension Lever back into its locked
position on the Generator (Figure 11).
Figure 8
Figure 9
Figure 11 Figure 10
ATM
Generator
Attachment Pin
Collar
Retaining Pin
Belt Tension Lever
Belt Tension Lever
Stow Clip
Engine
Pulley
Drive
Belt
Belt Tension
Pulley
ATM
Drive
Pulley
Generator
Stow Clip