DR Power 30 Snow Thrower - Manual (Page 25)

CALL TOLL FREE 1-800-DR-OWNER 21
Operating the DR SNOW THROWER ATTACHMENT
1. Use winter grade oil in your DR FIELD and BRUSH MOWER . See the Engine Owner’s Manual.
2. ALWAYS wear protective winter clothing and safety glasses during operation of this machine.
3. Set the Parking Brake on your DR FIELD and BRUSH MOWER.
4. Check to see that there are no obstructions in the Auger before you start the machine.
5. Make sure to adjust the Skid Shoes equally for the surface that you are clearing.
6. Make certain that the Shift Lever is in the Neutral position and the PTO (Blade Control) Lever is in
the Disengaged position (pulled back).
7. Start the engine in accordance with Chapter 4 of the Safety & Operating Instructions for your DR
FIELD and BRUSH MOWER.
8. After the engine has warmed up, set the Throttle to a moderate engine speed.
USE ONLY A MODERATE ENGINE SPEED WHEN ENGAGING THE PTO (BLADE CONTROL) LEVER.
ENGAGING THE DRIVE BELT AT A HIGH ENGINE SPEED WILL SHORTEN THE CLUTCH LIFE.
9. Make sure the Snow Thrower Auger is clear of snow before engaging the Drive Belt.
10. To start the Snow Thrower Auger, engage the PTO (Belt Drive) by pushing the Blade Control Lever
forward or pulling up on the Blade Control Knob for machines with an electric clutch.
11. Adjust the engine RPM to full throttle for maximum power. Low engine RPM may tend to clog the
Discharge Chute.
12. Move the DR FIELD and BRUSH MOWER Shift Lever to the desired gear and release the Parking Brake.
13. Gently squeeze the Wheel Clutch Lever to engage a gear.
14. Keep the area of discharge clear of people, animals, buildings, glass, or anything else that will obstruct
clear discharge, cause injury, or damage. Wind can also change discharge direction, so be aware.
15. Only operate the machine from the Operator Zone (see Figure 10 on page 14).
16. Keep proper balance and footing while operating the machine.
17. If the Auger strikes a foreign object or if your machine should start making an unusual noise or
vibration, immediately disengage the PTO, stop the engine and wait for all moving parts to come to a
complete stop. After the machine has come to a complete stop, inspect for any damage and repair or
replace any damaged parts before restarting and operating the machine.
18. Upon completion of your work, return the Throttle to Idle and allow the Auger to operate for a minute or
two to prevent the Auger from icing.
19. Disengage the PTO drive and turn off the engine. Be sure to remove the Key for safety.