DR Power 30 Snow Thrower - Manual (Page 19)

CALL TOLL FREE 1-800-DR-OWNER 15
Attaching the Optional Drift Cutters
BEFORE PERFORMING THIS PROCEDURE: STOP THE ENGINE, SET THE PARKING BRAKE, WAIT FOR ALL
MOVING PARTS TO COME TO A COMPLETE STOP, DISCONNECT THE SPARK PLUG WIRE(S), KEEPING IT
AWAY FROM THE SPARK PLUG(S), AND REMOVE THE KEY FOR SAFETY.
Tools Needed:
•
1/2" Wrench or Socket
1. Align the two (2) square holes in the Drift Cutter with the two (2) round holes in the side of the
Snow Thrower Housing (Figure 11).
2. Insert two (2) 5/16" x 5/8" Carriage Bolts, from the outside, through the Drift Cutter and the Snow
Thrower Housing (Figure 11).
3. Secure the Bolts in place with two (2) 5/16" Flange Nuts and tighten using a 1/2" Wrench or Socket
(Figure 11).
4. Repeat Steps 1 through 3 for the Drift Cutter on the other side of the Snow Thrower Housing.
Figure 11
Drift Cutter
Snow
Thrower
Housing
Carriage Bolt
Flange Nut