DNF Controls SW32PS-RCP - Manual (Page 9)

SW32PS-RCP Port Switcher Controller Page 5 5 o o f f 1 1 3 3
5. OPERATION
a. MAKE A ROUTE
1) Press [FROM]. The FROM indicator will turn on. The left side
of the display shows the currently selected FROM connector
(PORT1-32).
2) Turn the Wheel until the desired FROM point is displayed.
3) Press [TO]. The TO indicator will turn on. The right side of the
display shows the currently selected TO connector (PORT1-32).
Turn the Wheel until the desired TO point is displayed.
4) Press [TAKE] to route the FROM input to the TO output.
NOTE: No Route is made until [TAKE] is pressed.
NOTE: The Route that involves the selected FROM and/or TO will be
disconnected prior to making the new route.
b. VIEW THE ROUTES
1) Press [VIEW]. The VIEW indicator will turn on.
2)
Turn the Wheel to scroll through all ports that are displayed on
the first line of the display.
c. DISCONNECT ROUTE
1) Press [FROM].
2)
Turn the Wheel until OFF is displayed.
3) Press [TO].
4) Turn the Wheel to find the destination that you wish to turn off.
5) Press [TAKE] to turn off the route.
d. SAVE PRESET
1) Press [SHIFT] + [PRESET]. The PRESET indicator will turn
on. The first line of the display will show “Save Preset 1”.
2) Turn the Wheel to select preset number 1-8.
3) Press [TAKE] to save current configuration into the selected
preset.
OR
Press [ESC] to exit without saving.
e. RESTORE PRESET
1) Press [PRESET]. The PRESET indicator will turn on.
The first line of the display will show “Restore Preset 1”.
2) Turn the Wheel to select preset number 1-8.
3) Press [TAKE] to restore selected preset.
OR
Press [ESC] to exit without restoring.