Digi-Star GT465 - Manual (Page 38)

38
TROUBLESHOOTING
1. Press until DIAG is displayed.
2. Press to enable diagnostics.
3. The 3 line display will now show value from RPM sensor.
4. Press to disable diagnostics and return to normal operation.
NOTE: The RPM value should be close t
revolution.
For best results adjust the distance between the sensor and the targ
This is equal to the thickness of one to two quarters.
Sensor has yellow LED indicator on rear to indicate target in range of the sensor.
GT465 Operators Manual
TROUBLESHOOTING
RPM Sensor Diagnostics
is displayed.
diagnostics.
The 3 line display will now show value from RPM sensor.
to disable diagnostics and return to normal operation.
The RPM value should be close to the actual RPM’s of the shaft when detecting a single target per
For best results adjust the distance between the sensor and the target to between 0.1” and 0.2” (2mm
This is equal to the thickness of one to two quarters.
Sensor has yellow LED indicator on rear to indicate target in range of the sensor.
3
D3968 Rev A
o the actual RPM’s of the shaft when detecting a single target per
et to between 0.1” and 0.2” (2mm-5mm).
1
2 4