DFI BL600-D - Manual (Page 33)

33
2
Hardware Installation
Universal Serial Bus Connectors
The system board supports 12 USB 2.0/1.1 ports. USB allows data
exchange between your computer and a wide range of simultane-
ously accessible external Plug and Play peripherals.
The USB 0-5 connectors allow you to connect 6 additional USB 2.0/
1.1 ports. The USB ports may be mounted on a card-edge bracket.
Install the card-edge bracket to an available slot at the rear of the
system chassis then insert the connectors that are attached to the
USB port cables to these USB connectors.
BIOS Setting
Configure the onboard USB in the Integrated Peripherals submenu
(“USB Device Setting” section) of the BIOS. Refer to chapter 3 for
more information.
W
USB 5-4
USB 7
USB 6
USB 9
USB 8
1
2 1 0
9
VCC
VCC
-Data
-Data
+Data
+Data
Ground
Ground Key
N.
C
.
W USB 11
USB 10
W
USB 8-7
USB 2-1