DFI SR100-N - Manual (Page 53)

53
2
Hardware Installation
Chassis Instrusion Connector
The system board supports the chassis intrusion detection function.
Connect the chassis intrusion sensor cable from the chassis to the
chassis intrusion connector. Whenever a chassis component has been
removed, the sensor sends signal to the connector alerting you of a
chassis intrusion event.
Hardware Monitor for Windows
Install the “Hardware Monitor for Windows” utility. By default, the
chassis intrusion detection function is disabled. When enabled, a
warning message will appear when the chassis is open. The utility can
also be configured so that a beeping alarm will sound when the
chassis is open. Refer to the “Hardware Monitor for Windows” sec-
tion in chapter 4 for more information.
X
2
1 Ground
Chassis signal