DFI SR100-N - Manual (Page 46)

46
2
Hardware Installation
LVDS LCD Panel Connector
LCD/Inverter Power Connector
LCD AUX Power Connector
The system board allows you to connect a LCD Display Panel by
means of the LVDS LCD panel connector and the LCD/Inverter
power connector. These connectors transmit video signals and power
from the system board to the LCD Display Panel. The LCD AUX
power connector is used to connect auxiliary power to the LCD
panel.
Refer to the next page for the pin functions of these connectors.
Note:
Pins 33 to 40 of the LVDS LCD Panel connector are shared
with COM 1. If you are using this connector (meaning, the
COM 1 signals already preoccupied), only COM 2 will be
available.
Jumper Settings
Refer to the “Jumper Settings” section in this chapter for settings
relevant to the LCD panel.
BIOS Setting
Configure the LCD panel in the Chipset menu of the BIOS. Refer to
chapter 3 for more information.
LVDS LCD Panel
LCD/Inverter
Power
X
X
LCD AUX
Power
1
X
1 8
1
3
2
3 9
4 0