DFI SR100-N - Manual (Page 32)

32
2
Hardware Installation
Power-on Select
JP14 is used to select the method of powering on the system. If you
want the system to power-on whenever AC power comes in, set
JP14 pins 2 and 3 to On. If you want to use the power button, set
pins 1 and 2 to On.
When using JP14 “Power On” feature to power the system back on
after a power failure occurs, may not power on the system if the
power lost is resumed within 5 seconds (power flicker).
Note:
In order to ensure that power is resumed after a power failure
that may occur within a 5 second period, JP14 should be set to
pins 2-3 and the “Restore on AC Power Loss” in CMOS is set
to “Power On”.
1-2 On:
Power-on via
power button
(default)
2-3 On:
Power-on via
AC power
JP14
X 3
1
2
3
1
2