DFI HM100-HM86 - Manual (Page 29)

www.dfi .com
29
Chapter 3 BIOS Setup
Chapter 3
ACPI Settings
This section is used to configure the ACPI parameters.
Select ACPI sleep state
the system will enter when
the SUSPEND button is
pressed.
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
Version 2.15.1236. Copyright (C) 2012 American Megatrends, Inc.
ACPI Settings
ACPI Sleep State
Resume by PME
Resume by RTC Alarm
Advanced
[S3 only (Suspend to.....)]
[Disabled]
[Disabled]
ACPI Sleep State
Selects the highest ACPI sleep state the system will enter when the Suspend button is
pressed.
S3(STR) Enables the Suspend to RAM function.
Resume by PME
Enables this field to use the PME signal to wake up the system.
Resume by RTC Alarm
When Enabled, the system uses the RTC to generate a wakeup event.
 Select Screen
 Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized Defaults
F4: Save & Reset
ESC: Exit
Trusted Computing
This section configures settings relevant to Trusted Computing innovations.
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
Version 2.15.1236. Copyright (C) 2012 American Megatrends, Inc.
Confi guration
Security Device Support
Current Status Information
SUPPORT TURNED OFF
Advanced
[Disable]
 Select Screen
 Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized Defaults
F4: Save and Reset
ESC: Exit
Enables or Disables
BIOS support for security
device. O.S will not show
Security Device. TCG
EFI protocol and INT1A
interface will not be
available.
Security Device Support
This field is used to enable or disable BIOS supporting for the security device. O.S will
not show the security device. TCG EFI protocol and INT1A interface will not be
available.