DFI HM100-HM86 - Manual (Page 18)

www.dfi .com
18
Chapter 2 Hardware Installation
Chapter 2
Graphics Interfaces
DVI-I Port
The DVI-I port is used to connect an LCD monitor. This port supports DVI-D signal only.
Connect the display device’s cable connector to the DVI-I port. After plugging the cable con-
nector into the port, gently tighten the cable screws to hold the connector in place.
HDMI Port
The HDMI port which carries both digital audio and video signals is used to connect a LCD
monitor or digital TV that has the HDMI port.
BIOS Setting
Configure the display devices in the Chipset menu (“System Agent Configuration” submenu) of
the BIOS. Refer to the chapter 3 for more information.
The display ports consist of the following:
• 1 DVI-I port
• 1 HDMI port
DVI-I
HDMI
RJ45 LAN Ports
LAN 1
Features
• Intel ® I210 PCI Express Gigabit Ethernet controller
• Intel ® I217LM with iAMT9.0 Gigabit Ethernet Phy (HM100-QM87)
• Intel ® I217LM Gigabit Ethernet Phy (HM100-HM86)
The two LAN ports allow the system board to connect to a local area network by means of a
network hub.
BIOS Setting
Configure the onboard LAN ports in the Chipset menu (“PCH-IO Configuration” submenu) of
the BIOS. Refer to the chapter 3 for more information.
Driver Installation
Install the LAN drivers. Refer to the chapter 4 for more information.
LAN 2
LAN 2
LAN 1