DFI CA900-B - Manual (Page 45)

45
3
BIOS Setup
Super IO Configuration
This section is used to configure the I/O functions supported by the onboard
Super I/O chip.
Allows BIOS to Enable
or Disable Floppy
Controller.
BIOS SETUP UTILITY
v02.61 (C)Copyright 1985-2006, American Megatrends, Inc.
← → Select Screen
↑↓ Select Item
+- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
Configure Win627 & F81216DG Super IO Chipset
Onboard Floppy Controller
Serial Port1 Address
Serial Port1 IRQ
Serial Port1 Mode
Serial Port2 Address
Serial Port2 IRQ
Serial Port3 Address
Serial Port3 IRQ
Serial Port4 Address
Serial Port4 IRQ
PWRON After PWR-Fail
Watchdog Function
Advanced
[Enabled]
[3F8]
[4]
[Normal]
[2F8]
[3]
[3E8]
[4]
[2E8]
[3]
[Off]
[Disabled]
Onboard Floppy Controller
Enabled
Enables the onboard floppy disk controller.
Disabled
Disables the onboard floppy disk controller.
Serial Port1 Address to Serial Port4 Address
Auto
The system will automatically select an I/O address for the onboard serial
ports.
3F8, 2F8, 3E8, 2E8
Allows you to manually select an I/O address for the onboard serial ports.
Disabled
Disables the onboard serial port 1 and/or serial port 2.
Serial Port1 IRQ to Serial Port4 IRQ
Selects an IRQ for the onboard serial ports. This is not configurable if the Se-
rial Port Address fields are set to Disabled.