D-Link DES-1228P - Manual (Page 60)

5 5 6 6
ReAuthEnabled: This Enables or Disables the periodic
ReAuthentication control. When the 802.1X function is Enabled, the
ReAuthEnabled function is by default also Enabled.
QuietPeriod: Sets the number of seconds that the switch remains in
the quiet state following a failed authentication exchange with the
client. Default 80 seconds
SuppTimeout: Sets the switch-to-client retransmission time for the
EAP-request frame. Default is 12 seconds.
ServerTimeout: Sets the amount of time the switch waits for a
response from the client before resending the response to the
authentication server. Default is 16 seconds.
MaxReq: This parameter specifies the maximum number of times
that the switch retransmits an EAP Request packet to the client before
it times out the authentication session. Default is 5 times.
ReAuthPeriod: This command affects the behavior of the switch only
if periodic re-authentication is enabled. Default is 3600.
To establish 802.1X port-specific assignments, select the From and
To Ports and select Enable.
Security > Mac Address Table > Static Mac
This page provides two distinct features. The top table provides the
ability to turn off auto learning Mac address if a port isn't connected to
an uplink Switch (i.e. DHCP Server). By default, this feature is OFF
(disabled). The Macs listed on this table may only connect from
corresponding ports and VIDs, in order to protect the network from
illegal Macs.