Devolo dLAN TV Sat - Manual (Page 33)

|
Configuration 33
|
devolo dLAN TV Sat
|
4.4.3 Signal Settings
In the "Signal Settings" configuration dialogue, you can configure the reception
of digital satellite stations with the dLAN TV Sat:
TV/AV Source
In addition to the dLAN TV Sat Digital TV (DVB-S) 1, the CyberLink TV Enhance
program supports additional tuners that are connected to your computer or built
into it. Using the "Image source" option, you can select one of these receivers
as an alternative.
Region
Depending on your current location, you can receive programs offered by differ-
ent satellites. Under "Region", select the country where you are currently located
so that CyberLink TV Enhance can offer you the correct selection of available sat-
ellites.
Remember that your satellite antenna also has to be set up accordingly.
Even within the same country, a satellite may not be able to be received in all
areas. For example, the Astra satellite at 23.5° East covers only the extreme
western part of Germany.
Audio
Because audio transmission from the dLAN TV Sat to your computer is always
digital, this option cannot be changed if you select the corresponding receiver,
Digital TV (DVBS) 1. Another audio signal can be configured here in some
cases, but only if another receiver has been selected as the video source.
TV Audio Input
Instead of the audio signal transmitted by the dLAN TV Sat (TV Tuner Audio),
you can select an alternative sound input with the "TV Audio In" option. All
audio inputs currently configured in the Windows operating system are availa-
ble.
Because the audio signal is transmitted along with the picture as a data stream
from the dLAN TV Sat to CyberLink TV Enhance, the sound of the receiver can be
received via the option TV Tuner Audio only.