Devolo dLAN TV Sat - Manual (Page 18)

Initial use
|
|
devolo dLAN TV Sat
|
18
b
If the devolo software has been installed correctly on the desired computer,
a network connection to the adapter exists and Cyberlink TV Enhance has
been started, the red Connect LED on the dLAN TV Sat is illuminated.
3.3.2 Connection to the satellite antenna
The LNB or multiswitch of a satellite antenna is connected to the antenna con-
nection of the dLAN TV Sat using a coaxial cable with an F-connector. Carefully
plug the cable into the F-jack of the adapter and tighten the outer nut of the
connector.
Operating voltage of 16 to 18 V may be present at the coax connection of the
LNB. To prevent damage to the LNB or the dLAN TV Sat, connect the adapter to
the power grid via the power supply only after having made the connection to
the antenna.
Also check the alignment of the satellite antenna to the desired satellite(s). You
can obtain the necessary parameters (compass direction, tilt, etc.) from your sat-
ellite operator. If necessary, use a conventional satellite receiver and television
to check whether you can receive stations using the current installation.
Note that the LNB voltage for the dLAN TV Sat is present at the antenna input
only if a connection exists to a computer that is running Cyberlink TV Enhance.
This can be important when operating a satellite signal finder, for example.
How to tell when you have done it correctly
b If the satellite antenna and LNB are installed correctly, you can receive TV
and radio stations using a conventional receiver and television.
b
If a functional network connection to the desired computer exists, the
devolo software has been installed and CyberLink TV Enhance has been
started, TV and radio stations are found during a channel search.
3.3.3 Connection to the power grid
To connect the dLAN TV Sat to the power grid, plug the power supply into an
available power outlet and plug the DC connector into the DC IN 12V 1.5A
input on the tuner. Ensure that the power supply is fully inserted in the outlet.
How to tell when you have done it correctly
b
When you connect the power supply to the power grid and the dLAN TV Sat,
the Power LED is illuminated on the power supply and the green ON LED is
illuminated on the back of the tuner.