Devolo dLAN TV Sat - Manual (Page 27)

|
Configuration 27
|
devolo dLAN TV Sat
|
Once both dLAN 200 AV adapters have been successfully connected, press each
encryption button for two seconds within two minutes of one another. That's
it! Your dLAN 200 AV network is now protected against unauthorised access.
ባ Expanding an existing dLAN 200 AV network using a new dLAN 200
AV adapter (e.g. the dLAN TV Sat)
If you have already secured your existing dLAN 200 AV network using the
encryption button, use the same method to integrate further adapters. Once you
have successfully connected the new dLAN 200 AV adapter to the socket, first
press the encryption button of one of your network’s existing adapters (two sec-
onds), then press the encryption button of your new dLAN 200 AV adapter (two
seconds) within two minutes. That's it! The new dLAN 200 AV adapter is now
integrated in your network.
To integrate additional dLAN 200 AV adapters in your network, repeat the above
steps.
ቤ Removing a dLAN 200 AV from the network
To remove a dLAN 200 AV adapter from an existing network, press its encryption
button for at least ten seconds. The device will be assigned a new randomly
generated password and will thus no longer be able to access the network. To
integrate the adapter in a different dLAN 200 AV network, follow the steps
described under
ቢ or ባ, depending on whether you are setting up a new net-
work or adding the adapter to an existing one.
4.3.2 Encrypting the dLAN 200 AV network with the dLAN Con-
figuration Wizard
You can also configure the encryption of the data transmitted via the dLAN using
the dLAN Configuration Wizard.
If you use a dLAN adapter without an encryption button in your network, you
have to use the Configuration Wizard to set up encrypted data transmission.
After successfully installing the devolo software, you can launch dLAN Config-
uration Wizard from this program group: Start
! All Programs ! devolo, or
using the Device ! Start dLAN Configuration Wizard in devolo Informer.
Before beginning with this step, make a note of the security IDs of all existing
dLAN adapters. This unique identifier of each dLAN device is located on the label
on the underside of the housing. It consists of 4 x 4 letters or figures separated
by dashes (e.g. ANJR-KMOR-KSHT-QRUV). Ensure that all dLAN adapters are