beautypg.com

Fuse replacement, General specifications, Fcc registration information – Dataprobe PowerPal Dual User Manual

Page 8

background image


Model PP-NC-03 / K-103

Page 8



FUSE REPLACEMENT

In the event that the device connected to Pal fails to power up when commanded to, inspect the fuse
located at the rear of PowerPal EXP. Before removing the fuse, disconnect Pal from its A/C source.
Then remove the fuse by rotating the top of the fuse holder with a screwdriver.

If the fuse is visibly damaged, replace it with the same type and rating 250V 10 Amp fuse (5 X 20 mm).

GENERAL SPECIFICATIONS


Electrical

Model PP-NC-03 #1410014

120 VAC 60 Hz. , 10 Amps maximum switching capacity
Power Input: NEMA 5-15P Linecord
Switched Outlet: NEMA 5-15R Receptacle

Model PP-NC-03-220 #1410019
220 VAC 50-60Hz, 10 Amps maximum switching capacity
Power Input: IEC 320 C14 Line Cord
Switched Outlet: IEC 320 C13 Recptacle

Total power = Connected load + 60 Watts

Physical

Table top unit - UL 94V-0 rated plastic
Dimensions - 8” x 6.25” x 2.75”
Weight - 4.0 lbs.


FCC REGISTRATION INFORMATION

Power Pal FCC registration number: DNMUSA23923-OT-N REN: 0.4B


This equipment complies with Part 68 of the FCC rules. On the bottom of this unit is a label that contains, among other
information, the FCC registration number and ringer equivalence number (REN) for this equipment. If requested, this
information must be provided to the telephone company. REN is used to determine the quantity of devices on which may be
connected to the telephone line. Excessive RENs on the telephone line may result in the devices not ringing in response to
an incoming call. In most, but not all areas, the sum of RENs should not exceed five (5.0). To be certain of the number of
devices that may be connected to the line, as determined by the total RENs, contact the local telephone company.

This equipment is des igned for use with USOC registered jack RJ11. It is intended for single line use, and may not be used
on public coin phone service provided by the telephone company. Connection to party line service is subject to state tariffs
(contact state public utility commission, public service commission or corporation commission for information). An FCC
compliant telephone cord and modular plug is provided with this equipment. This equipment is designed to be connected to
the telephone network or premises wiring using a compatible modular jack which is Part 68 compliant. See Installation
section for details.

If Power Pal causes harm to the telephone network, the telephone company will notify you in advance that temporary
discontinuance of service may be required. If advance notice is not practical, the telephone company will notify the customer
as soon as possible. Also, you will be advised of your right to file a complaint with the FCC if you believe it is necessary. The
telephone company may make changes i n it’s facilities, equipment operations or procedures that could affect the operation of
this equipment. If this happens, the telephone company will provide advance notice in order for you to make necessary
modifications to maintain uninterrupted service. No repairs may be made by the user. If trouble is experienced with Power
Pal contact Dataprobe (201.967.9300) for repair or warranty information. If the equipment is causing harm to the telephone
network, the telephone company may request that you disconnect the equipment until the problem is resolved.