beautypg.com

Dataprobe Serial iBootBar User Manual

Page 11

background image



Serial iBootBar v111207e

Page 11

Device Commands

Command

Description

Access

Fact Default

get outlets

This command displays a list of connected devices, and their current
status.

User

set name

Set the name of the selected iBootBar. 20 characters max.

User

get current

Gets the measured current of the iBootBar

Admin

get external control

Get or set external control capability. Enabling this will allow the
external inputs to control its corresponding outlet.

Admin

enable

set external control

get cycle

Get or set the cycle time in seconds. Cycle time is the time that the
outlet will be off during a reboot (on

– off – on) or on during a cycle (off

– on – off)

User

10

set cycle <1-99>

get delay

Get or set the delay time in seconds. When multiple outlets are turned
On by a single command, this delay controls the interval between
powering up of the outlets. This delay is used to limit power up inrush.

User

1

set delay <0-99>

get current alarm

High and Low alarms are used to monitor current conditions and send
an alert via the serial port when the high or low thresholds are
exceeded.
From 0.0 to 10.0/15.0 (depending on max current for device) in 0.1
amp increments.

Admin

Highalarm:
10.0 for 10 Amp
Models
15.0 for 15 Amp
Models
Lowalarm:
0.0 Amp

set main a highalarm

set main a lowalarm

get logon

Disabling logon bypasses the username and password requirements
and allows direct machine to machine communications. No logon
prompt will be issued.

Admin

Enabled

get logon