Daktronics StatVision for Baseball - Manual (Page 3)

StatVision for Baseball Quick Start Guide 3 of 7
201 Daktronics Drive PO Box 5128, Brookings, SD 57006-5128
Tel: 1-800-DAKTRONICS (1-800-325-8766) Fax: 605-697-4700
Web: www.daktronics.com
ED-17884 Rev 3
12 April 2012
To check the sign number in V-Net:
a. On the V-Net computer, right-click the V-Net Manager
icon in the task bar ( ) and select Control Panel.
b. Click on the Edit Configuration Settings tab.
Note: If the sign number is 0, change it to any number that is
not already being used. If multiple signs are set to 0, the same
data and commands will be sent to every sign on the network
configured with that sign number.
6. In the Display Port column, select the port to be used for the sign
from a list of available ports supplied by DSTI.
Note: A display port can only be selected once. If more than two
signs are controlled, contact Daktronics to have the DSTI
configuration file modified.
7. Use the Drives column to select the drive letter(s) where content is
stored for the selected sign.
8. If using a V-Net controller, be sure to click in the Control Port
column and then click Yes.
9. Click OK to save the sign.
After a sign has been configured, it will appear as a button on the top of the
StatVision screen. Click a sign once to enable it (green). Click a sign again to
turn it off (red). At least one sign must be checked to output stats/messages.
Set Up Sequences
When a certain combination of stats is to be displayed, StatVision tells the
display controller to play a sequence that matches the selected data.
Note: At a minimum, there must be a sequence for 1 Category/3 Stats
and 1 Category/4 Stats. It is not necessary to create sequences for every
possible category/stat combination.
Creating Sequences
Sequences are built on the Venus 7000 or Show Control computer. They
determine the layout of the statistics and standings on the sign, including
how many and what statistics are to be displayed. Separate sequences are
required to display leaders and standings. Refer to the manual for further
assistance with creating display sequences.
Setting Up In-game Sequences
1. Go to Edit > Sequences.
2. Type in the name of each desired sequence into the table as named
on the Venus 7000 or V-Net computer.
Note: Any file name may be used for the sequences, but it is
recommended to use names such as “1_3” for simplicity.