Daktronics StatVision for Baseball - Manual (Page 2)

StatVision for Baseball Quick Start Guide 2 of 7
201 Daktronics Drive PO Box 5128, Brookings, SD 57006-5128
Tel: 1-800-DAKTRONICS (1-800-325-8766) Fax: 605-697-4700
Web: www.daktronics.com
ED-17884 Rev 3
12 April 2012
Sharing the Daktronics Folder
If the DakStats and StatVision programs are on different computers, the
directory where the DakStats database is located must be shared:
1. Go to the computer with the DakStats program.
2. Browse to the C:\Daktronics directory.
3. Right-click the folder.
4. Select Sharing and Security.
5. Share the folder with full permissions.
*Note for Windows 7 users: After right-clicking the folder, select
Properties, and click on the Sharing tab. Click on Advanced
Sharing, select Share this folder and click OK.
Set Up Data Configuration
Note: Open a demo game in DakStats before performing the following steps.
1. Open StatVision.
2. Go to Edit
> Data Configuration.
3. In the Data Configuration window, click the […] button.
4. Locate the “Baseball” folder within the “Daktronics” folder that
was just shared on the DakStats computer.
5. Click OK to save the data configuration.
Set Up Signs
Sign configuration allows the user to configure the display that StatVision
will control and send information to. At least one sign must be configured.
Configuring Signs
1. Open the Daktronics Scoring-Timing Interface (DSTI), if not already
running, by clicking on the DSTI icon on the desktop.
 DSTI is typically installed on the same computer as DakStats.
 The RTD ports available in StatVision are configured in DSTI by
Daktronics.
2. Open StatVision, either on the same computer as DSTI or on a
separate computer.
3. Go to Edit > Signs, and the Sign Configuration window will appear.
4. In the Sign Name column, enter a descriptive name for the sign. The
name of the sign can be anything that makes sense to the operator.
5. In the Sign # column, select the sign number of the sign that
StatVision will controll.
To check the sign number in Venus 7000:
a. On the Venus 7000 computer, open the Venus 7000 Shell.
b. Go to Configure > Signs.
c. Double-click the desired sign, and go to the Advanced tab.