Daktronics Stat Crew Interfaces - Manual (Page 2)

Stat Crew Interfaces Quick Guide 2 of 4
201 Daktronics Drive PO Box 5128, Brookings, SD 57006-5128
Tel: 1-800-DAKTRONICS (1-800-325-8766) Fax: 605-697-4700
Website: www.daktronics.com/support
DD1701004 Rev 4
26 July 2013
Baseball
1. Press [O] to open the SCOREBOARD VERSION. If this option is not
available, refer to the installation CD or contact Stat Crew.
2. Go to Remote display > Comms setup.
3. Enter NONE in the Comm port field and leave the Baud and Terminal
settings as is.
4. Select B for box score in the Auto-send field.
5. Press [Ctrl+Enter] to save the changes.
6. Select Send, press [F4], or enter a play to create the "comfile" output
that will be used by TasComms32.
7. Skip ahead to TasComms32 Setup.
Basketball
The TAS Basketball software automatically creates and updates a file named
"c:\statcrew\comfile.sb" when users enter the Gametime Scoring screen and
after recording each play. The only additional setup required is to open the
in-game options and set Full subs to Yes.
Below are some additional suggestions to keep in mind when using the
software to send stats to a display:
1. When setting up a roster, all single-digit jersey numbers must have a
leading zero (EX: Player No. 2 is entered as “02”).
2. Player names must be entered as “lastname,firstname” with no space
after the comma.
TasComms32 Setup
Note: Make sure that the latest version of TasComms32 is installed.
It is available in the Downloads section of the Stat Crew website.
1. Go to Start > Programs > TasComs32 > TasComms32.
2. Configure the Data Source in the left column:
 Select Scoreboard data under Incoming data format.
 Select the appropriate Sport.
 Ensure the Monitor file field correctly matches the Sport:
“c:\statcrew\comfile.sb” for basketball
“c:\tasbs\comfile” for baseball
“c:\tasfb\comfile” for football
“c:\tashk\comfile” for hockey
“c:\tasvb\comfile” for volleyball
Note: For basketball only, confirm that “.sb” is at the end of
the text in the Monitor File field.