Denon AVR-1910 - Manual (Page 26)

2
ENGLISH
Get
ting Star
ted
Connections
Pla
ybac
k
Remot
e Contr
ol
Inf
or
mation
Tr
oubleshooting
Specifications
Multi-Zone
Making the Optimum Settings for the Connected Speakers Automatically (Audyssey Auto Setup)
• If the result differs from the actual connection status or an error mes-
sage appears, use ui to on-screen display “Retry” and then press
to repeat the measurement.
• If the result still differs from the actual connection status after re-
measurement or the error message still appears, it is possible that
the speakers are not connected properly. Turn the AVR-1910 off,
check the speaker connections and repeat the measurement pro-
cess from the beginning.
• For instance, If the location or direction of a speaker is altered, the
Audyssey Auto Setup should be performed again to ensure the cor-
rect EQ solution for the new room configuration.
NOTE
Do not change the speaker connections or subwoofer volume, or
speaker locations after making measurements. If changes are neces-
sary, make the changes and use the Audyssey Auto Setup once again
for an updated EQ solution.
8
Press .
This returns you to analysis results items, so repeat
step 7.
9
Press i to select “Next”, then
press .
10
Press ui to select
“Store”, then press
.
“Storing Please wait...” is
displayed on the on-screen
display while the results
are being stored.
When storing is complete,
“Storing complete. Auto
Setup is now finished.” is
displayed on the on-screen
display.
b If you do not want to save
the measurement results,
use
ui to select “Cancel”,
then select “Yes” using
o p . All the measured
Audyssey Auto Setup data
will be erased.
NOTE
Do not turn the power off while the settings are being stored.
12
Disconnect the setup microphone from the AVR-
1910.
Step5:Store
MultEQ
Store
Cancel
[ENT]:Store
Please select “Store”
to store measurement
values.
⇩
Step5:Store
MultEQ
Storing
Please wait...
Front
Set
tings