Daktronics S-100/S-200 - Manual (Page 8)

Introduction 1-2
The following box, Figure 1, is an illustration of a Daktronics drawing label. The drawing number is
located in the lower-right corner of the drawing. This manual refers to drawings by listing the last set
of digits and the letter preceding them. In the following example, the drawing would be referred to as
Drawing A-114667.
All references to drawing numbers, appendices, figures or other manuals are presented in bold
typeface, as shown below.
“Refer to Drawing A-114667 for the location of the load center.”
In addition, any drawings referenced within a particular sub-section are listed at the beginning of that
sub-section in the following manner:
Reference Drawing: Shop Drawing;16 High 2 ½” Small Matrix................Drawing A-114667
Referenced drawings are found in Appendix B.
Daktronics identifies manuals by an ED number located on the cover page of each manual. Any
manuals referenced in this manual will be identified by its ED number. For example, this manual would
be referred to as ED-10191.
The serial number and model numbers can be found on the ID label, located on the display. This label
will look similar to the one shown in Figure 2. When calling Daktronics Customer Service, please have
this information available to ensure that your request is serviced as quickly as possible.
Daktronics displays are built for long life and require little maintenance. However, from time to time,
certain display components will need replacing. The Replacement Parts List in Section 4.6 provides
the names and part numbers of components that may need to be ordered during the life of this display.
Following the Replacement Parts List is the Exchange/Replacement Procedure. Refer to these
instructions if any display component needs to be replaced or repaired.
Figure 1: Drawing Label
Figure 2: Display ID Label